![]() test fire, and if no misfires, then the headspace should be correct///once fitted from or to another gun, they most often drop right in, just do not want it TOO loose, gaps ( headspace issues) the proof is in the actual test firing of the gun.if it spins, turns, and locks up, and stays locked up ( in battery) your OK.simple work the action on the "UNLOADED" gun before shooting it.the overall length of the new cylinder should be the same as the one that came with the gun. ![]() face and the rear of the barrel, so its NOT rubbing and you have about>004-.006 " of an inch, too much gap you can get 'blow by", then the other end, the bottom of the cartridges should NOT 'drag' against the recoil shield. Top, Magnum marked Single-Six, model 'RSSM', serial number 301416 shipped with a Magnum only cylinder and varnished walnut grips. Now I'm shown a field to enter the serial number and the web site comes back with the. Thread starter jimbo1096 Start date Help Support Ruger Forum: 1 jimbo1096 Hunter. Until this week, every time I looked up a serial number, Ruger's web site presented me with a table (list) of a models' numbers and approximate date of manufacture. CAL in two lines on the left side of the cylinder frame. Why does the serial number history listing skip from 62 to 69. Welcome to the forum, on any old model over 150,000 serial number range if you put the cylinder, and pull back ( cock the hammer) and it LOCKS up on every chamber, you should be good to go.look at the spacing in front of the cylinder, between the cyl. They were roll-marked RUGER SINGLE-SIX WIN.22 RF MAG.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |